Troubleshooting - Philips Lumea BRI858 Manual De Instrucciones

36
English
Pulse duration
Duration of the pulsetrain
Pulse interval
Maximum optical energy

Troubleshooting

Problem
The
device/adapter
becomes warm
during use.
When I place the
device on the
skin, it does not
release a flash.
The 'ready to
flash' light blinks
orange.
The ready to flash
light blinks
orange and all 5
intensity lights
blink as well.
This chapter summarizes the most common
problems you could encounter with the device. If
you are unable to solve the problem with the
information below, visit www.philips.com/support
for a list of frequently asked questions or contact
the Consumer Care Center in your country.
Possible cause
This is normal.
Your skin tone in
the area to be
treated is too dark.
The device needs
to be reset.
0.8 +/ -0.2 mSeconds
Single pulse
0.9-1.9s
(BRI863/BRI863/BRI864)
1-3-2.9s (BRI860/BRI861)
1.5-3.5s (BRI858)
5.7 - 12.8J
Solution
No action required.
Treat other body areas
with lighter skin tones with
Lumea.
To reset the device take
the plug out of the socket,
wait for 30 minutes to let
the device cool down. The
device should function
normally again. In case it
doesn't work again,
contact the Consumer Care
Center in your country.