Troubleshooting - Philips HP6608 Manual Del Usuario

Cleaning the epilating head
1 Push the epilating head in the direction of the
arrows on the back of the appliance (1) and remove
it (2) (Fig. 15).
2 Remove loose hairs with the cleaning
brush (Fig. 16).
3 Rinse the epilating head under the tap for 5-10
seconds while turning it (Fig. 17).
4 Shake the epilating head firmly (Fig. 18).
Dry the epilating head thoroughly with a tea towel.
Note: Make sure the epilating head is completely dry before
you place it back onto the appliance.
Replacement
All parts of the appliance can be replaced. If you need to
replace one or more of the following parts, go to your
Philips dealer or an authorised Philips service centre:
- appliance itself
- epilating head
- sensitive area cap
- opti-start cap with massage element
- hair-lifting attachment with massage element
- cleaning brush
- adapter
Environment
- Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an official collection point for recycling. By doing
this, you help to preserve the environment (Fig. 19).
Guarantee & service
If you need service or information or if you have
a problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care
Centre in your country (you find its phone number in
the worldwide guarantee leaflet). If there is no Consumer
Care Centre in your country, go to your local Philips
dealer.

Troubleshooting

This chapter summarises the most common problems
you could encounter with the appliance. If you are unable
to solve the problem with the information below, contact
the Consumer Care Centre in your country.
Problem Cause
Poor epilating You move the
results. appliance in the
wrong direction.
You place the
epilating head on
the skin at the
wrong angle.
You used a
(depilatory)
cream prior to
epilation.
The hairs are too
short.
4203.000.4314.1
Problem
The appliance
does not work.
I cannot
remove the
epilating head
from the
appliance.
Solution
Move the appliance
against the direction of
hair growth, with the
on/off slide pointing in
the direction in which
you move the appliance.
Make sure that you
place the appliance on
the skin at an angle of
90° (see chapter 'Using
the appliance').
Make sure your skin
is clean, entirely dry
and free from grease.
Do not use any cream
before you start
epilating.
Sometimes hairs are too
short to be caught. The
optimal length for easy
removal of the hairs is
3-4mm. The hairs that
are not caught during
this session will be long
enough to be removed
when you epilate the
next time. You can also
try to catch the hairs by
moving the appliance
across the skin a few
more times.
Cause Solution
The Do not use the sensitive
sensitive area area cap when you
cap is on the epilate your legs, as the
epilating head cap reduces the number
when you epilate of active epilating
your legs. discs. NB: Never use
the epilator without
the sensitive area cap
when you epilate your
underarms or bikini line.
The socket Make sure the socket
to which the is live. If you have
appliance is connected the epilator
connected is to the socket in a
not live. bathroom cabinet, you
may need to switch on
the bathroom light to
activate the socket.
You try to pull it Push the epilating
straight off. head in the direction
of the arrows on the
back of the appliance
before you pull it off
the appliance (see
chapter 'Cleaning and
maintenance').
3/9