Timer Operation; Off Timer - Sharp CV-P10NC Manual De Instalación Y Funcionamiento

TIMER OPERATION

OFF TIMER

The unit will turn off automatically according to your setting.
Timer duration can be set from a minimum of half an hour (30 minutes) to a maxi-
mum of 12 hours.
Up to 9.5 hours, you can set in half-hour (30-minutes) increments and from 10 to
12 hours, in 1-hour increments.
Display shown when you
set the unit to turn off 2.5
hours later.
NOTES ON TIMER SETTING AND OPERATION
• The latest time setting will be memorized and will appear on the remote control display the next
time you set the OFF TIMER or ON TIMER.
• The OFF TIMER and ON TIMER can not be set together.
Only the most recent TIMER setting will be valid.
• While the ONE-HOUR OFF TIMER is set, the OFF TIMER and ON TIMER is settings are una-
vailable.
• If the ONE-HOUR OFF TIMER is set while the OFF TIMER or ON TIMER activated, the ON
TIMER or OFF TIMER setting will be cancelled.
• If a power failure occurs while the OFF TIMER or ON TIMER is set, the TIMER setting will be can-
celled and will not be retrieved even after the power is restored.
Point the remote control at the signal receiver win-
dow on the unit.
1
Press the OFF TIMER button and set the
time as desired.
• The time setting will change as you press the but-
ton as follows.
0.5h
Hold the button down to speed through the set-
tings.
• The orange TIMER lamp on the unit will light.
1
• The unit will emit a beep when it receives the sig-
nal.
• The time setting will count down to show the re-
maining time.
TO CANCEL TIMER
Press the CANCEL button.
• The orange TIMER lamp on the unit will turn off.
E-24
1.0h 1.5h 10h 11h 12h