Warranty Regulations - Migatronic MCU 1000 Guía De Usuario

Maintenance and Warranty regulations
Maintenance
The module equires periodical maintenance and cleaning in
order to avoid malfunction and to ensure long-time operational
reliability.
Insufficient maintenance will influence the operational
reliability and result in lapse of warranty.
WARNING !
Only trained and qualified staff members can carry out
maintenance and cleaning. The machine must be disconnected
from the mains supply (pull out the mains plug!). Thereafter,
wait around 5 minutes before maintenance and repairing, as
all capacitors need to be discharged due to risk of shock.
Cooling unit
• Check cooling liquid level and frost protection and refill
cooling liquid as required.
• At least once a year, clean the water tank and the water
hoses in the welding hose for dirt and rinse with clean
water. Then add new cooling liquid. The machine comes
with a cooling liquid, which consists of demineralized water,
propylene glycol and benzotriazole. The cooling liquid
provides frost protection to –12°C. See article number in
the spare parts list. The cooling liquid is not considered
hazardous waste. Waste can be disposed of through the
municipal waste disposal system.
Dispose of the product and cooling liquid according
to local standards and regulations.
More information can be found under Policies at
www.migatronic.com

Warranty regulations

Migatronic (which is hereinafter referred to as "the Supplier")
continuously carries out quality control throughout the
manufacturing process as well as check of the complete units
through comprehensive testing.
The Supplier provides warranty in accordance with the
following provisions, by correcting errors and defects on units,
that demonstrably and within the warranty period may have
been caused by faulty material or workmanship.
The warranty period is 24 months for new welding machines,
12 months for new accessories and 6 months for spare parts.
The warranty period is calculated from the date of invoice
to the end user from the Supplier or the Supplier's dealer/
distributor. The original invoice is proof of the warranty period.
The warranty period is 12 months or maximum 1,800 operating
hours for the CoWelder solution. The warranty period is
calculated from the date of invoice to the end user from the
Supplier or the Supplier's dealer/distributor. The original invoice
is proof of the warranty period.
The warranty period is 24 months for new welding machines
incorporated in robotic, automated and CoWelder solutions.
The warranty period is calculated from the date of invoice
to the end user from the Supplier or the Supplier's dealer/
distributor. The original invoice is proof of the warranty period.
The warranty period can be extended to up to 60 months on
selected parts by registration at
welding machines not later than 30 days after the date of
purchase. The following welding machines fall within the scope
of the extended warranty: Automig, Automig-i, MIGx series,
Sigma Select, Omega series, Sigma series, Sigma Galaxy, Pi
series, Pi Plasma, Zeta.
Welding torches and intermediary cables are considered
as wearing parts, and only errors and defects found within
12 months upon delivery and due to faulty material or
workmanship, will be considered under warranty.
Warranty repairs neither extend nor renew the warranty
period.
Any transport of goods or persons in connection with a
warranty claim is not covered under the Supplier's warranty
obligation and will therefore be at the buyer's expense and risk.
You can read the complete Warranty Conditions at
www.migatronic.com.
10
www.migatronic.com of new