Spraying Troubleshooting; Unclogging The Spray Tip - Titan XL255 Manual Del Propietário

Spraying Troubleshooting -

If the spray pattern becomes distorted or stops completely while the gun is triggered, follow these steps.
Do not attempt to unclog or clean the tip with your
finger. High pressure fluid can cause injection injury.
IMPORTAnT: Do not use a needle or other sharp pointed
instrument to clean the tip. The hard tungsten carbide can chip.
1. Release the trigger and lock the trigger off (see
page 7). Rotate the reversible tip arrow 180º so
that the point of the arrow is toward the rear of
the gun (CLEAN position).
under pressure, the spray tip may be very
difficult to turn. Turn the PRIME/SPRAY knob
to PRIME and trigger the gun. This will relieve
pressure and the tip will turn more easily.
2. Turn the PRIME/SPRAY knob to SPRAY.
3. Unlock the trigger and squeeze the trigger, pointing the
gun at a scrap piece of wood or cardboard. This allows
pressure in the spray hose to blow out the obstruction.
When the nozzle is clean, material will come out in a
straight, high pressure stream.
If material still will not spray from the spray tip,
follow the Cleaning the spray gun filter instructions,
page 12.
4. Release the trigger and lock the trigger off (see
page 7). Reverse the tip so the arrow points
forward again (SPRAY position). Unlock the gun
and resume spraying.

unclogging the Spray Tip

CLEAn
SPRAY
SPRAY
11
Trigger locked
(see page 7)
LX05
LX60
Trigger locked
(see page 7)
LX05
LX60
English