Drive Belt Replacement - RIDGID K-60SP Manual De Instrucciones

K-60SP Drain Cleaning Machine
Figure 11 – Remove Socket Head Cap Screws
2. Remove the jaw housing. The clutch jaw assembly is
contained in the jaw housing.
3. Remove the jaw set cover by rotating counter-clock-
wise (Figure 12).
4. Clean the clutch jaw assembly, jaw cover, and the in-
side of the jaw housing.
5. If worn, replace the clutch jaw assembly.
6. Reinstall the jaws into the jaw housing and replace the
jaw set cover.
7. Rotate the adjustment knob clockwise until the jaw set
touches the jaw set cover. This will insure that the jaw
set is properly aligned.
8. Attach jaw housing to machine with socket head cap
screws.
NOTE! Make sure flanges on plastic shroud are con-
tained inside the jaw housing.
Figure 12 – Remove Jaw Set Cover

Drive Belt Replacement

1. Stand the machine up on the front of the frame. Make
sure clutch handle is in its uppermost position.
Remove the two (2) socket head cap screws from the
jaw housing with a
2. Remove the jaw housing.
3. Loosen the jam nut on the side of the machine (Figure
13).
4. Rotate motor adjustment set screw counter-clock-
wise with
removed.
Ridge Tool Company
1 / " hex key. (Figure 11)
4
3 / " hex key until belt is loose enough to be
16
11