Advice For Use; Identifying Damages - Zummo Z14 Manual Del Usuario

12

ADVICE FOR USE

•
Always make sure you are using the right squeezing set of Balls, Cups and Fruit Classifier
for the size of fruit you wish to squeeze. If the fruit to squeeze is too big or too small for the
squeezing kit used, the quality of the juice may decrease, getting a bitter juice flavour.
The Hopper Fruit Classifier must be correctly selected according to the size of the fruit to
•
squeeze.
If fruits are too large for the Fruit Classifier, they fruit will not fall into the Cup.
•
If otherwise, fruits are too small, numerous pieces of fruits will fall at the same time into the
•
Cup.
•
We recommend to switch off the machine when is not going to be used. (Fig. 3)
13

IDENTIFYING DAMAGES

Damage
The display is not lit
The display shows message
Error
The display shows message
Error and a flashing Icon.
Blade breaks
Not enough juice is being
extracted from the fruit
Hooper is not delivering fruits
so the squeezing area
Hooper is delivering several
oranges at the same time into
the squeezing area
For any advice or to request spare parts, you should state the model and serial number of your machine (Fig.
2).
20
Cause and/or solution
No power supply.
Fuse burnt out. (Fig. 16)
Power cable not properly connected.
Switch power on. (Fig. 3)
Damp in circuit board. Supply dry heat to the board.
Casing not fitted correctly (Disp. 5). (Fig. 7)
Hopper Track not fitted correctly. (Disp. 5)
Filter Tray not assembled or incorrectly assembled (Disp. 6). (Fig.8)
Disp. 5
Check if the fruit is frozen.
Check for piled-up fruit peels inside the Juicetray.
Check if Balls are correctly tightened
Check to see if the orange peels are stuck to the inside of the Cups.
Check if components of different squeezing sets are mixed
To unblock the machine, use the 5mm Allen key located at the right of the lower
vent. Insert it into the hole on the right side and, with the machine switched off, turn
clockwise until the cups are raised, removing the obstruction. WARNING: Make
sure the Allen key is removed before switching the machine on.
The Peel Extracting Bands are loose or broken and peels are piling up in the
Juicertray.
Cup nuts are too loose.
Balls are loose.
The low-pass filter is missing.
Fruit peel is too thin. Place one extra washer under each ball.
Fruit is too big for the Fruit Classifiler in use.
Fruit is too small for the Fruit Classifier in use.
Hopper not properly assembled. See section nº 9 of this manual.
Disp. 6