TECNO R-evolution Instruction manual
ByTecnoplus
s.r.l.
CENTRAL VACUUM SYSTEMS
6 - AUTHORIZED USE OF THE VACUUM CLEANER
The TECNO R-EVOLUTION vacuum cleaner has been designed exclusively to vacuum clean house
dust, very small-size solids and dry materials. The use of the central vacuum cleaner is authorized
for household and civil uses, connected to a PVC wall-traced piping network and to a standard home
electrical wiring.
The vacuum cleaner can be installed in domestic dwellings with the following characteristics:
• Surface to be cleaned ranging from 30 to 450 m²
• Piping network featuring 50-mm diameter pipe
• 220/240 V ac power supply
• Air exhaust conveyed to the outside
• Suitable for a single-operator use
• Suitable for installation in domestic spaces such as store rooms, boiler rooms, garages and balconies.
7 - UNAUTHORIZED USE OF THE VACUUM CLEANER
It is extremely important NOT to use the system in the following circumstances which are conside-
red to be inappropriate and dangerous:
• The system must not be used to vacuum clean fabrics, heavy or hot/burning materials.
• The system must not be used to vacuum clean liquids.
• Do not suction cement, fl our or similar materials, which may cause the reduction of the vacuumed air
with a consequent damage of the motor.
The system has not been designed to be used in environments with risk of explosion, and the-
refore:
• it is forbidden to vacuum clean materials with high explosion risk (gunpowder) or materials which are
individually inert but that, once collected and mixed in the dust bin, could provoke dangerous chemical
reactions.
• It is absolutely forbidden to use the vacuum cleaner in explosive atmosphere or outside the standard
temperature, pressure and humidity levels.
• Do not vacuum any material which may cause electrostatic charges in the piping system, if not
previously communicated to the constructor.
Any use of the appliance other than those specifi ed above is forbidden.
Any change or modifi cation made to the system in order to vacuum clean a particular type of
material must obtain the prior written approval of the manufacturer.
The use of the system for purposes other than those for which it was manufactured, represents
an irregular condition which can cause damage to the product and seriously compromise the
operator's safety.
16
21/01/16 Rev:3.0.0