TECNOPLUS Sistem-air Domestic TECNO R-evolution Serie Manual Tecnico página 76

TECNO R-evolution Instruction manual
ByTecnoplus
s.r.l.
CENTRAL VACUUM SYSTEMS
9.7.2 Connection to the piping network (bag suction see pages 9-11)
1. If the service suction inlet is already assembled on the body of the appliance remove it being careful
not to damage the inserted gasket.
2. In case of fi rst installation, the body of the vacuum cleaner body is completely disconnected; for this
reason, install the elbow coupling, provided with the kit, in the lower hole, being careful to position
the sealing gasket in the internal side between the coupling and the body.
3. By means of the screws and washers provided in the BI-VAC kit, screw the elbow coupling to the
appliance body on the outer side of the cylinder.
4. Remove the conveyor cone from the dust collection bin.
5. Position the ring seal with gasket in the special housings in the internal sides of the machine body.
6. Insert the bag, being careful to put it at the bottom end of the elbow coupling.
7. Repeat the steps described in the previous paragraph being careful to connect the pipe coming from
the pipe network to the end of the elbow coupling on the appliance body (E).
8. Place the closing cover (F) at the end of the coupling of the cyclonic dust suction inlet, identifi ed with
(A) in the previous drawing since it will be no longer used; leaving this open will break-off the system
suction power.
Should it be necessary to convey the air discharge to the outside, please follow the following
instructions:
Maximum length of the discharge pipe:
Diameter of the outlet pipe for a length up to 4 m:
Diameter of the outlet pipe for lengths from 4 to 6 m:
Diameter of the outlet pipe for lengths from 6 to 8 m:
Diameter of the outlet pipe for lengths from 8 to 10 m:
It is not advisable to use an outlet pipe which is longer than 10 m, because this could damage
the central vacuum unit.
26
F
E
50 mm
63 mm
80 mm
100 mm
21/01/16 Rev:3.0.0