Starting Operation; Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch PSM 80 A Manual Original

OBJ_DOKU-2339-002.fm Page 16 Thursday, December 13, 2007 2:40 PM
16 | English
For the working of all
wooden materials
For coarse-sanding, e. g.
of rough, unplaned
beams and boards
For face sanding and plan-
ing small irregularities
For finish and fine sand-
ing of hard woods
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of prim-
ers before coating
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V can
also be operated with 220 V.
Switching On and Off
To start the machine, push the ON/Off switch 1
downward to position "1".
To switch off the machine, push the On/Off
switch 1 upward to positon "0".
1 609 929 N20 | (13.12.07)
Grain size

Working Advice

40 — 180
The removal capacity during sanding is mainly de-
termined by the selection of the sanding sheet.
Only flawless sanding sheets achieve good sand-
ing capacity and extend the service life of the ma-
coarse 40
chine.
Pay attention to apply uniform sanding pressure;
medium 80, 120
this increases the working life of the sanding
sheets.
fine 180
Intensifiying the sanding pressure does not lead
to an increase of the sanding capacity, but to in-
40 — 180
creased wear of the machine and the sanding
sheet.
For precise on-the-spot sanding of edges, cor-
ners and hard to reach areas, it is also possible
to work only with the tip or an edge of the sand-
coarse 40
ing plate.
medium 80, 120
A sanding sheet that has been used for metal
should not be used for other materials.
fine 180
Use only original Bosch sanding accessories.

Maintenance and Service

Maintenance and Cleaning

If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article number
given on the type plate of the machine.
Wait until the machine has come to a stand-
still before placing it down.
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
Bosch Power Tools