Types Of Work; Pressing Out Compound; Removing The Cartridge; Removing The Foil Pack - Hilti CD 4­A22 Manual De Instrucciones

6. Screw on the front panel again.
We recommend pressing the piston rod forward until resistance is felt. The piston is now rests on
the cartridge and application can then be started as quickly as possible.
6

Types of work

6.1 Comply with all safety instructions and instructions for use.
WARNING
Chemicals hazard Incorrect use can lead to injury.
▶ Prior to use, read and comply with the safety data sheet for the product, the instructions on the packaging
and the instructions for use of the foil pack.
6.2

Pressing out compound

1. Press the switch.
2. Press out the compound.
The speed with which the compound is output can be varied with the aid of the speed control wheel.
6.3

Removing the cartridge

1. Press the release button.
2. Pull the piston rod back as far as they will go.
3. Lift the cartridge at the front and pull it out of the cartridge holder.
6.4

Removing the foil pack

1. Unscrew the front panel.
2. Remove the nozzle together with the remaining foil pack.
7

Care and maintenance of the product

7.1

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
8 English
Printed: 29.07.2019 | Doc-Nr: PUB / 5466599 / 000 / 02
2221133
*2221133*