Tecfrigo BRIO 96 Instalación Y Uso página 7

6. CONTROLS
The appliance is supplied with adjusting controls. .
2. Refrigeration unit switch:
temperature in the appliance.
4 SET or P " " once to display the temperature set-point, which can be changed by pressing button
or button 6 "DOWN" (see figure 4).
7. CHECKING CORRECT OPERATION BEFORE USE
CHECK THAT: 1. The appliance is plugged in.
3.
green light is on. The thermometer shows the desired temperature for the goods to be stored. . The
internal lights are on. 5. The door is completely closed.
or high-powered lamps. . The room temperature does not exceed that in which the appliance is 7
designed to work normally, i.e. +30°C R.H. 55%, (climatic class 4).
motor compartment; there is a clearance of at least 30 cm in front of the grille. . The cabinet is suitably
filled and shelves are not overloaded; there are sufficient gaps to enable cold air to circulate.
8. INTERNAL CLEANING (EVERY 15 DAYS)
1 . Switch off the appliance. . Open the door and remove the refrigerated goods.
accessories of the appliance with a sponge dipped in water with a little sodium bicarbonate.Dry with care.
9. REPLACING THE INTERNAL LIGHTS
1 . Switch off the appliance. . Undo the fastening screws of a lamp socket.
with its protective cover from the lamp socket. . Take the tube out of the other lamp socket. . Remove
6.
the protective cover. Replace the fluorescent tube. . Reassemble by following the above instructions
in reverse order (see fig. 5).
Operator's guide
1 Light switch:
to switch on the refrigeration unit.
Thermostat: to adjust the temperature in the appliance.
2. The refrigeration unit switch is switched on with the
2
2
4
7
to switch on the internal lights.
3. Thermometer:
6. The appliance is not exposed to direct sunlight
8. There is sufficient ventilation for the
9
3. Detach the fluorescent tube
7
to read the
a) Press button
5 "UP"
4
3. Wipe the walls and
5
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO