Sub-Zero UW-24 Manual Del Usuario página 7

M ODE L UW- 24 | UW- 2 4 F S I N S TA L L AT I O N
Custom Panel
Adjustments can be made to the custom panel with a few
mounting screws in place, but not fully tightened. Once the
proper position is achieved, install and secure all screws.
Cover the holes on the inside of the door frame with the
cover patches or plugs provided.
CAUTION
A solid panel cannot be installed over the glass door. A
solid door is available through an authorized Sub-Zero
dealer. For local dealer information, visit the find a
showroom section of our website, subzero.com.
Placement
CAUTION
Before moving the unit into position, secure the door
closed and protect any finished flooring.
Use an appliance dolly to move the unit near the opening.
If the unit has been on its back or side, it must stand upright
for a minimum of 24 hours before connecting power.
If the unit will be connected to a home security system,
run lead wires through the compressor compartment prior
to positioning the unit. Refer to page 8. Once the unit is in
position, the wiring connections can be completed from the
front.
Leveling
Level the unit before sliding it into position. Turn each of the
four leveling legs clockwise to raise the unit and counter-
clockwise to lower. Refer to the illustration below.
LEVELING LEGS
Leveling
|
subzero.com 7