Sub-Zero UW-24 Manual Del Usuario página 8

M ODE L UW- 24 | UW- 2 4 F S I N S TA L L AT I O N
Completion
Plug the power cord into the grounded outlet, then slide
the unit into position. Verify the anti-tip bracket is properly
engaged.
It may be necessary to install the unit
front surface of adjacent cabinetry to prevent interference
when the door is opened to 145°. Refer to the full-scale
template on page 9.
H OME S E CUR I T Y C O NN E C T I O N
If the unit will be connected to a home security system,
make connections to the leads shown in the illustration
below. Refer to the following color codes:
• Normally open contacts—white with red stripe wire.
• Normally closed contacts—white with blue stripe wire.
• Common—gray with white stripe wire.
Use the spade terminals or wire nuts provided to make
proper wiring connections.
CAUTION
The alarm circuit in the unit is intended as a low-
voltage, low-current device only. It should not be used
to switch line power. Any unused terminals should be
completely insulated and all wires should be secured
away from conductive or moving components.
HOME SECURITY
LEADS
Home security connection
|
8 Sub-Zero Customer Care 800.222.7820
1 / " beyond the
(6)
4
AN C H O R IN G
To anchor, use the countertop bracket provided to secure
the unit to the underside of the countertop. Refer to the
illustration below. If the countertop bracket cannot be
used, install shims along the top and sides of the unit.
K IC K PL ATE I N STALLATI ON
Install the kickplate using the two screws provided. Refer
to the illustration below. The kickplate must be removable
for service. The floor cannot interfere with removal. Do not
cover the louvered section of the kickplate.
COUNTERTOP
BRACKET
Anchoring
KICKPLATE
Kickplate installation