Advanced Wlan Settings; Wlan Security Settings - Nokia E75 Manual Del Usuario

WLAN settings
Select Menu Control panel
>
Connection Wireless
>
To have an indicator displayed when there is a wireless LAN
(WLAN) available in your current location, select
availability > Yes.
To select the interval for your device to scan for available
WLANs, and to update the indicator, select
networks. This setting is not available unless you select
Show WLAN availability
To set the device to test the internet capability of the selected
WLAN automatically, to ask for permission every time, or to
never perform the connectivity test, select
connectivity test Run
>
or Never run. If you select
test to be performed when the device asks for it, and the
connectivity test is performed successfully, the access point
is saved to internet destinations.
To check the unique media access control (MAC) address that
identifies your device, enter *#62209526# in the home
screen. The MAC address is displayed.

Advanced WLAN settings

Select Options Advanced
>
settings are normally defined automatically, and changing
them is not recommended.
To edit the settings manually, select
configuration > Disabledand define the following:
© 2009 Nokia. All rights reserved.
Settings and
>
LAN.
Show WLAN
Scan for
> Yes.
Internet
automatically, Ask every
Run automatically or allow the
settings. The advanced WLAN
Automatic
Long retry limit
•
transmission attempts if the device does not receive a
receiving acknowledgement signal from the network.
Short retry limit
•
transmission attempts if the device does not receive a
clear-to-send signal from the network.
RTS threshold
•
WLAN access point device issues a request to send before
sending the packet.
TX power level
•
when sending data.
Radio measurements
•
measurements.
Power saving
•
saving mechanism to save the power in the device battery.
Using the power saving mechanism enhances the battery
time,
performance but may weaken WLAN interoperability.
To restore all settings to their original values, select
Options Restore
>

WLAN security settings

Select Menu
>
Connection
>
the instructions on the display.
To edit a wireless LAN (WLAN) access point, open one of the
access point groups, and select an access point marked with
.
To enter the settings for the selected security mode, select
WLAN security
— Enter the maximum number of
— Enter the maximum number of
— Select the data packet size at which the
— Select the power level of your device
— Enable or disable the radio
— Select whether to use the WLAN power
defaults.
Control panel Settings
>
Destinations Access
>
settings.
and
point, and follow
147