Voice Command Settings; Push To Talk; About Push To Talk; Log In And Exit Ptt - Nokia E75 Manual Del Usuario

To change the voice command, select
Change command.

Voice command settings

Select Menu Control panel
>
Select Options Settings
>
Synthesizer — Activate the synthesizer that plays
•
recognized voice commands.
Playback volume — Adjust the speech volume.
•
Recognition sensitivity
•
recognition sensitivity.
Command verification
•
commands are accepted automatically, manually, or by
voice verification.
Remove voice adapts.
•
learning when the main user of the device has changed.

Push to talk

Some features may not be available in your region. For
availability, contact your service provider.
Select Menu Applications
>

About push to talk

Push to talk (PTT) (network service) is a real-time, voice-over-
IP service that uses a GSM or GPRS network. PTT provides
direct voice communication, with the push of a key. Use PTT
68
Profiles Options
>
Phone Voice comm..
> >
and from the following:
— Adjust the voice command
— Select whether the voice
— Reset voice recognition
> PTT.
to have a conversation with one person or with a group of
>
people.
Before you can use PTT, you must define the PTT settings
(access point, PTT, SIP, XDM, and Presence). You may receive
the settings in a special text message from the service
provider that offers the PTT service. You can also use the
Settings wizard application to configure PTT, if supported by
your service provider. For more information on the PTT
application, see the user guide for your device or your local
Nokia website.
In PTT communication, one person talks while the others
listen through the built-in loudspeaker.
Speakers take turns responding to each other. Because only
one group member can talk at any time, the maximum
duration of a speech turn is limited. The maximum duration
is usually set to 30 seconds. For details of the speech turn
duration for your network, contact your service provider.
Phone calls always take priority over push to talk activities.

Log in and exit PTT

When you start the push to talk (PTT) service, you are
automatically logged in and connected to the channels that
were active the last time you closed the application. If the
connection fails, to attempt to log in again, select
Log in to PTT.
To exit PTT, select Options
To switch to another open application, press and hold the
menu key.
Options
> Exit.
© 2009 Nokia. All rights reserved.
>