Microlife PF100 Manual De Instrucciones página 15

7. A long beep confirms that the
result is recorded. PEF is
displayed for about 3 seconds
followed by FEV1 and then the
monitor is ready for a new
measurement which is indicated
by two short beeps.
8. It is recommended to perform
three or more measurements
sequentially.
9. After each measurement, at first
the actual reading is shown in
the display and then it switches
automatically to the highest
reading of your current
measurement session.
note that the monitor only
saves the highest reading
from switching the device on
until switching it off.
10. Press the ON/OFF button again to
switch the monitor off. Before
the monitor switches off, the
highest value of the current
measurement session and its
related memory position «MR xx»
is displayed.
13
Please