3.2. Setting Date and Time
Once set, the monitor automatically
records the time and date of each
measurement. After new batteries have
been inserted, the time/date display shows
the following setting: year: 2004; day 12,
month 04 and time 12:00 am o'clock.
You must then re-enter the date and
current time. To do this, proceed as follows
(Example: Entering 15th June 2004,
09:50am o'clock):
1.
Open the Data Compartment from
underneath at the position of the
data symbol indication.
2.
Press the small time button next
to the clock symbol with a paper
clip and «2004» starts blinking;
release the switch.
3.
Using the two arrow keys on the
front of the monitor you can
decrease (left arrow button) or
increase (right arrow button) the
number. Release the arrow
button when the correct number
is reached.
Please note: If you hold down the
arrow key for more than 2
seconds it speeds up.
8