Description Of Machine Parts - Sandri Garden SG 925/30 CS Manual De Instrucciones

PETROL CHAIN SAW FOR TREE SERVICE USER MANUAL
operator's hands are used as
described above.
The chain saw is fitted as stand-
ard with the following safety de-
vices:
B1 - THROTTLE LATCH (see fig.1
item 8) avoids the throttle lever from
being accidentally operated.
THROTTLE LEVER (fig.1 item 9).
DANGER: Be aware that the cutting
chain will continue to turn for some
time after the throttle lever is re-
leased.
B2 – STOP SWITCH (fig.1 item 11)
when the lever is lowered [
- fig.27] the engine is stopped.
Fig.27
B3- SAFETY CHAIN BRAKE The
chain saw is fitted with a safety chain
brake (fig.1 item 6) which locks the
chain in position (in the event of a
kickback) in a fraction of a second.
B4 – CHAIN LATCH PIN (Fig.1 item
1). This device prevents the chain
from being thrown off in case of
breakage (or if the chain comes off
3. DESCRIPTION OF MACHINE
PARTS
1)
2)
3)
"0"
STOP
4)
5)
6)
7)
8)
9)
10)
11)
12)
13)
14)
15)
16)
17)
18)
19)
20)
21)
22)
23)
24)
25)
26)
the guide bar groove) during its op-
eration.
Before each use, check that all
safety devices are fully opera-
tional.
If not, do not use the chain saw
and contact an approved service
centre to have it repaired.
DESCRIPTION Fig.1
Chain lock latch pin
Chain
Chain guide bar
Guide bar guard
Spike
Hand front guard / Safety chain brake
lever
Right hand top handle
Throttle lever latch
Throttle lever
Left hand front handle
Engine stop switch [STOP]
Fuel flow adjustment screws
Fuel tank cap
Chain oil tank cap
Starting cable handle
Guide bar tightening nuts
Chain tensioner screw
Chain tensioner tooth
Chain brake cover
Starter
Air filter cover
Exhaust silencer
Air filter cover knob
Support cord hook
Choke/throttle advance knob
Fuel primer
31