Broan Elite E64000 Serie Manual De Instalación página 5

1. SELECTBLOWEROPTIONAND INSTALLATION TYPE
1.1
NON=DUCTED iNSTALLATiON
For a non-ducted installation, a non-duct kit ANKE60 Series (sold separately) must be installed. For maximum effectiveness,
we recommend installing this kit with a single (internal) blower hood. The kit fits hoods from 30-inch width up to 48-inch
width. See installation instructions included with the non-duct kit ANKE60 Series.
1.2 DUCTED iNSTALLATION
The Broan Elite E64000 Series range hood includes many configurations: hood with single or double internal blowers
(included with the hood), or hood using external blowers. For hood using external blowers, the Broan Elite E64000 Series
must be installed with in-line blower models HLB3, HLB6, HLB9 or HLB11, or exterior blower model 331 H, 332H, 335 or
336 only. Other blowers cannot be substituted. (Blowers sold separately).
Plan where and how the ductwork will be installed.
If installing in=line blower, refer to instructions packed with in=line blower and follow steps 1,2, 3, 4, 10 and up of
this manual.
install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing, if using 7", 8" or 10"
round ducts, use a transition (internal blower(s) only). Use 2" duct tape to seal duct joints.
The minimum hood distance above cooktop must not be less than 24". A maximum of 30" above cooktop is highly
recommended for best capture of cooking impurities.
Distances over 30" are at the installer and users discretion.
Roof cap
Wall
3W' x 10" duct
or 7" or 8" round duct
x 10"to 7" or
x 10" to 8" transition
(if using round duct)
Hood
24" minimum above
cooking surface
SINGLE iNTERNAL BLOWER
TYPICAL DUCTWORK
Roof cap
10" round duct
4V2" x 18V2"to 10"
Wall
Hood
L24" minimum above
cooking surface
HH0086A
DOUBLE iNTERNAL BLOWERS
TYPICAL DUCTWORK
Exterior blower
duct
24" minimum above
cooking surface
HH0087A
MODEL 331 H, 332H, 335 OR 336
EXTERIOR BLOWER
TYPICAL DUCTWORK
-5-
__Roof cap
10" round duct (except_'-_l
L
HLB3,.8" round duct) _-----L__]] _
- /
Wall
cap
24" minimum
above cooking
surface
HH0092A i
MODEL HLB3, HLB6, HLB9 OR HLB11
IN-LINE BLOWER TYPICAL DUCTWORK