Oakley DETONATOR Manual De Instrucciones página 7

10 DETONATOR INSTRUCTION MANUAL
ADJUSTING THE CHRONOGRAPH HANDS
Under normal conditions, the chronograph minute hand and 1/5-second hand are reset to zero
(the 12-o'clock position) by using the watch buttons. In some instances, such as during the initial
setup of the watch, it may be necessary to manually adjust these hands to the zero position.
A
POS 1
B
[ADJUSTING THE CHRONOGRAPH HANDS CONT. ON NEXT PAGE]
TO ADJUST THE POSITIONS OF THE
CHRONOGRAPH HANDS:
1. Pull the crown out to the second click position.
2. Press and hold button (a) for two seconds.
The chronograph minute hand will advance
one full rotation to indicate that it can now
be adjusted. Press button (b) repeatedly
until the chronograph minute hand is set to
zero (the 12-o'clock position). Press and hold
button (b) to advance the hand rapidly.
3. Press and hold button (a) for two seconds.
POS 2
The chronograph 1/5-second hand will
advance one full rotation to indicate that it
can now be adjusted. Press button (b)
repeatedly until the chronograph 1/5-second
hand is set to zero (the 12-o'clock position).
Press and hold button (b) to advance the
hand rapidly.
4. Push the crown back in to the normal position.
WHEN ADJUSTING THE POSITIONS OF
THE CHRONOGRAPH HANDS, NOTE
THE FOLLOWING:
• The procedure is necessary only when the
chronograph hands do not reset to zero
when the watch buttons are used.
• While the crown is in the second click
position, pressing button (a) for two-second
intervals will cycle the function of button (b)
among three adjustment modes: (1) Setting
the zero position of the chronograph minute
hand, (2) Setting the zero position of the
chronograph 1/5-second hand, (3) Setting
the position of the alarm hands.
DETONATOR INSTRUCTION MANUAL 11
ADJUSTING THE CHRONOGRAPH HANDS (cont.)
A
POS 1 POS 2
B