Electrical Connections For Adaptive Infrared; Adjust The Temperature - Bradley Terreon 54 Manual Del Usario

TDB3108, WF3208
6

Electrical connections for Adaptive Infrared

Do not use for two minutes after making power
connection. The sensors will take up to eight minutes
(without being used) to adapt to the bowl if another
object is detected during the two-minute start-up period.
Connect the three wires from the
infrared module assembly to the valve
assembly . Attach two of the female
A
connect wires to the solenoids . Attach
the male connect wire to one of the
24 VAC transformer leads . Attach the
remaining transformer lead to the
solenoid wire adapter .
B
Connect 24 VAC transformer
(provided) to power source .
C
Turn supplies on . Open check/stop
valves completely .
D
Open volume control valve completely
and check piping installation for leaks .
E
Pass your hand in front of each sensor
until air is purged from the lines .
7

Adjust the Temperature

This Vernatherm TMA valve is NOT factory preset. Upon installation, the
temperature of this valve must be checked and adjusted to ensure delivery of a
safe water temperature. Water in excess of 110°F (43°C) may cause scalding.
A
Check the temperature and adjust if
necessary (the range of the valve is
95°F–115°F (35°C–43°C) . To adjust the
temperature, follow the procedure below:
• Loosen temperature locking nut with
a wrench .
• Using a blade screwdriver, turn the
adjustment stem counterclockwise to
increase the temperature or clockwise
to decrease the temperature .
• Once desired temperature is reached,
tighten nut to prevent temperature
cahnge .
16
Window
(269-1351)
(S53-272)
Temperature
Adjustment Stem
4/30/2013
IR Module
(S50-344)
B Black
C Red
(S53-261A)
Wire Adapter
(269-620)
F = Female Connect
M = Male Connect
Temperature
Locking Nut
Bradley • 215-1187 Rev. P; ECN 13-00-001
Top View Module
A Red
Assembly Connect
(S53-261A)
Wires as shown
Valve Assembly
(S50-369
110/24 VAC
Transformer
(S83-134)
S53-261
Clean sprayhead if necessary .
B
Adjust the volume control
valve, if necessary, to control
the flow of water .
Attach pedestal access panel
C
and kick plate with hardware
provided .
Installation