Bowl/Pedestal Mounting And Assembly - Bradley Terreon 54 Manual Del Usario

Installation
2

Bowl/Pedestal Mounting and Assembly

Position the pedestal at desired location
A
and mark the position of the (4) mounting
locations .
TAS OPTION: Place TAS spacer on floor
over the mounting holes . Place pedestal on
top of the spacer .
Secure pedestal to floor with suitable
B
fasteners, 1/2" anchors and bolts (supplied
by installer) . Do not overtighten .
Using three or four people, carefully lift
bowl (see Figure 4b) on to pedestal making
C
sure drain holes line up with floor drain
and mate thread rods with slotted holes in
pedestal using locator ribs .
D
Using 1/4" wing nuts and washers, secure
the bowl to the pedestal in (4) places .
Front View
Place hands here
when lifting bowl
Locator Ribs (4)
Bradley • 215-1187 Rev. P; ECN 13-00-001
Places
1/4" Washers and
Wing Nuts (4) Places
CAUTION! Bowl surface is very smooth. Approximate
weight of bowl is 190 pounds. Handle with Care!
Top View
Threaded Rod
(4) Places
TDB3108, WF3208
Floor Mounting (4)
Place hands here
when lifting bowl
Threaded Rods
(4) Places
Drain
4/30/2013
Drain
Places
9