Intended Use; Technical Data - Parkside PSDS 240 A1 Manual De Instrucciones Original

4. Intended use

The grinder/sander is a combination device for
the coarse and fi ne grinding/sanding of metals,
woods of all kinds and other materials using the
appropriate grinding/sanding wheel or belt.
The machine may only be used with grinding/
sanding wheels or belts which are suitable for it
and comply with the characteristic data in these
instructions.
The machine is allowed to be used only for its
intended purpose! Even when the equipment is
used as prescribed it is still impossible to eliminate
certain residual risk factors. The following hazards
may arise in connection with the machine's const-
ruction and layout:
•
Contact with the grinding wheel where it is not
covered.
•
Catapulting of parts from out of damaged
grinding wheels.
•
Catapulting of workpieces and parts of work-
pieces.
•
Damage to hearing if essential ear-muffs are
not used.
•
Harmful emissions of wood dust when used in
closed rooms.
•
The rotating parts of the device cannot be
covered for functional reasons. Therefore you
must exercise care and hold the workpiece
firmly to prevent it slipping which could result
in your hands coming into contact with the
grinding/sanding belt.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufac-
turer will be liable for any damage or injuries of
any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Anl_4466145.indb 51 Anl_4466145.indb 51
GB/MT

5. Technical data

Rated voltage: ................................230 V ~ 50 Hz
Power rating: ...........................240 W S2 30 min
Idle speed n : ........................................2950 min
0
Ø grinding wheel: ......................................150 mm
Grinding wheel thickness: ...........................20 mm
Ø grinding wheel hole: ............................12.7 mm
Max. circumferential speed: ................ 23.17 m/s
Belt speed: ............................................900 m/min
Grinding /sanding belt: .................. 50 x 686 mm
Weight: .......................................................... 7.2 kg
Load factor:
A load factor of S2 30 min (intermittent periodic
duty) means that you may operate the motor
continuously at its nominal power level (240 W)
for no longer than the time stipulated on the speci-
fi cations label (30 minutes ON period). If you fail
to observe this time limit the motor will overheat.
During the OFF period the motor will cool again
to its starting temperature.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level ...........................89 dB(A)
pA
K uncertainty .................................................3 dB
pA
L sound power level ..........................102 dB(A)
WA
K uncertainty ................................................3 dB
WA
Wear ear-muffs.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 61029.
Vibration emission value a
K uncertainty = 1.5 m/s
- 51 -
-1
≤ 2.5 m/s 2
h
2
22.04.13 13:23 22.04.13 13:23