HP LaserJet 9040mfp Guía De Instalación Inicial página 28

1
2
3
4
6
26 Product Setup
To load Tray 4
Tray 4 holds up to 2,000 sheets. For media specifications, see the use
guide.
1 Pull Tray 4 open until it stops.
2 Adjust the left (Y) paper guide by pressing the tab on the guide and
set the guide to the correct paper size.
3 Adjust the front (X) paper guide by pressing the tab on the guide
and set the guide to the correct paper size.
4 Load up to 2,000 sheets of A4- or Letter-size paper with the short
edge of the paper leading into the product.
Note
For single-sided printing of letterhead or preprinted paper, the side to be
printed on should be facing down. For double-sided printing of
letterhead or preprinted paper, the first side to be printed on should be
facing up.
For information about printing on special media, see the use guide.
5 Set the Custom/Standard switch to Standard if both guides are set
to the same Standard marking, such as Letter or A4. Otherwise, set
the switch to Custom.
6 Press down on each of the four corners of the paper stack to ensure
the paper rests flat in the tray, without bending.
ENWW