Change The Control Panel Overlays - HP LaserJet 9040mfp Guía De Instalación Inicial

Step 9. Change the control panel overlays
1
3
4
5
6
ENWW
The control panel comes either with English overlays installed or with no
overlays. If necessary, use the following procedure to change the control
panel overlays.
1 Locate the two control panel overlays.
2 Lift the top cover of the product.
3 Insert a small, flat-blade screwdriver or other thin, narrow device in
the slot at the top edge of one of the overlays.
4 Lift the overlay up and backward to move it away from the product.
5 Position the new overlay over the control panel. Align the ends of
the overlay with the holes on the control panel and slide the overlay
in.
6 Snap the overlay firmly onto the control panel. Ensure that the
overlay is flat against the control panel.
7 Repeat steps 3 through 6 to change the second overlay.
8 Close the top cover.

Change the control panel overlays 19