Panasonic AW-RP555L Manual De Instrucciones página 8

Parts and their functions
SHUTTER button
This is used to select the shutter speed of the camera in the pan/tilt head system
currently selected.
Each time the button is pressed, the set shutter speed is switched to shutter OFF or vice
versa.
The shutter speed is actually switched as soon as the button is released.
At any setting except OFF, the button's lamp lights; at the OFF setting, it is off.
[How to register the shutter speed]
1. Press the SHUTTER button while holding down the MEMORY button.
2. The PRESET [1 to 5] buttons and PRESET [6 to 10] buttons start flashing alternately.
3. Press the PRESET button that corresponds to the shutter speed to be registered.
The table below lists the shutter speeds which can be set.
1/120 PRESET 1
1/250 PRESET 2
1/500 PRESET 3
1/1000 PRESET 4
1/2000 PRESET 5
K When OFF is set, the shutter will not be operated even when the SHUTTER button
is pressed.
Select the SYNCHRO-SCAN setting from the camera menu.
The change in the shutter speed is reflected when the shutter is next set to ON.
This setting is retained in the memory even after the control panel's power has been
turned off.
[ When temporarily changing the shutter speed without registering it]
Press the PRESET button corresponding to the shutter speed to be set while holding
down the SHUTTER button.
Refer to the table above for the shutter speeds which can be set.
The shutter speed will be changed as soon as the PRESET button is pressed.
This setting will be cleared when either the shutter button is pressed or the camera's
power is turned off.
1/4000
1/10000
SYNCHRO-SCAN
ELC
OFF
7 (E)
PRESET 6
PRESET 7
PRESET 8
PRESET 9
PRESET 10