Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
C. RH and LH Drive Control
Levers
The RH and LH control
levers are located on each side of
the operator's
seat. These hinged levers pivot outward
to open space to permit the operator to either sit in the
tractor seat, or to dismount
the tractor. The levers must be
fully opened out and in the neutral position
to start the
tractor engine.
Each lever controls the respective
RH or LH transmission.
Consequently,
these levers control all of the movements
of the tractor. Driving and steering
utilizing these control
levers is quite different
from conventional
tractors, and
will take some practice to master. Refer to Operation
for
instructions
on using the control
levers.
D. Ignition
Switch
The ignition
switch is located on the RH console to the
right of the operator's
seat. The ignition
switch has three
positions
as follows:
Figure 4-2
OFF -The engine and electrical
system is turned off.
ON - The tractor electrical
system is energized.
START - The starter motor will turn over the engine. Release
the key immediately
when the engine starts
NOTE: To prevent accidental starting and/or battery
discharge, remove the key from the ignition switch when the
tractor is not in use.
E. Power Take-Off
(PTO) Switch
The PTO switch is located on the RH console to the right of
the operator's
seat.
Figure 4-3
The PTO switch operates the electric PTO clutch mounted
on the bottom
of the engine crankshaft.
Pull the switch
knob upward to engage the PTO clutch, or push the knob
downward
to disengage the clutch.
The PTO switch must be in the "disengaged"
position
when starting the engine.
F. Transmission
Bypass Rods (Not Visible)
The transmission
bypass rods (one for each the RH and LH
transmission)
are located beneath the frame platform,
just
inside each rear wheel.
When engaged, the two rods open a bypass within
the
hydrostatic
transmissions,
which allows the tractor to be
pushed short distances by hand. Refer to Maintenance
&
Adjustments
for instructions
on using the bypass feature.
_
AUTION: Never tow your tractor. Towing
the tractor with the rear wheels on the
ground
may cause severe damage to the
transmissions.
G. Cup Holder
The cup holder is located toward the rear of the RH console
to the right of the operator's
seat.
H. Storage
Tray
The storage tray is located at the rear of the RH console.
J. Seat
Adjustment
Lever
(Not
Seen)
The seat adjustment
lever is located below the front/left
of the seat. The lever allows for adjustment
of the fore to
aft position
of the operator's
seat. Refer to Maintenance
& Adjustments
for instructions
on adjusting
the seat
position.
K. Fuel Tank Cap
The fuel tank cap is located near the middle of the LH
console. Turn the fill cap approximately
1/4 turn and pull
upward to remove. The fuel cap is tethered to the tractor to
prevent its loss, Do not attempt to remove the cap from the tractor.
Push the cap downward
on the fuel tank fill neck and
turn approximately
1/4 turn clockwise to tighten
Always
re-install the fuel cap tightly onto the fuel tank after
removing.
_
ARNING!: Never fill the fuel tank when the
engine is running.
If the engine is hot from
recently running, allow to cool for several
minutes before refueling.
Highly flammable
gasoline could splash onto the engine and
cause a fire.
L. Hour Meter
/ Indicator
Panel
The hour meter/indicator
panel is located on the LH
console to the left of the operator's
seat.
Battery
Indicator-
PTO
Engaged -
Indicator
-o
Oil Pressure
- Indicator
Hour Meter
Parking Brake
- Engaged
Indicator
Figure 4-4
SECTION 4
--
CONTROLS AND FEATURES
11
Publicidad
Tabla de contenido
