Cub Cadet RZT Series Manual Del Operador página 21

Ocultar thumbs Ver también para RZT Series:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

_
WARNING!
: Do not tow the tractor, even with
the bypass rod engaged.
Serious transmission
damage will result from doing so.
From just in front of the two rear tires, locate the
transmission
bypass rods. Refer to Figure 6-3.
Pull one rod toward the front of the tractor until the
flange on the rod is forward of the keyhole slot in the
frame assembly.
Lower the bypass rod into the keyhole slot and release
so the rod flange is against the front of the frame
bracket.
RHT_nsmission
Bypass Rod
Pull out
Bypass Rod
Lower
in Slot
Keystone
Slot
Figure 6-3
Repeat the above procedure
to engage the other
bypass rod on the other side of the tractor.
After moving the tractor, disengage
both bypass rods.
Lift the rod and guide the flange of the rod back
through
the larger circular opening
of the keyhole,
then release the rod.
IM PORTANT: The tractor will not drive with the bypass rods
in the engage position.
Battery Storage
When storing the tractor for extended
periods,
disconnect
the negative battery
cable. It is not
necessary to remove the battery.
All batteries discharge during storage. Keep the
exterior of the battery clean, especially the top. A dirty
battery will discharge
more rapidly.
The battery
must be stored with a full charge. A
discharged
battery can freeze sooner than a charged
battery. A fully charged battery will store longer in cold
temperatures
than hot.
Recharge the battery
before returning
to service.
Although
the tractor may start, the engine charging
system may not fully recharge the battery.
TractorStorage
If your tractor is not going to be operated
for an extended
period of time (thirty days to approximately
six months),
the tractor should be prepared for storage. Store the
tractor in a dry and protected
location. If stored outside,
cover the tractor (including
the tires) to protect
it from
the elements. The procedures
outlined
below should be
performed
whenever
the tractor is placed in storage.
1. Change the engine oil and filter following
the
instructions
provided
in the engine manual packed
with this manual.
WARNINGh
Never store the tractor with fuel
in the tank indoors or in poorly ventilated
enclosures, where fuel fumes may reach an
open flame, spark or pilot light as on a furnace,
water heater, clothes dryer, etc.
2.
If storing the tractor for 30 days or more:
To prevent gum deposits from forming
inside the
engine's carburetor
and causing possible malfunction
of the engine, the fuel system must be either
completely
emptied,
or the gasoline must be treated
with a stabilizer
to prevent deterioration.
WARNINGh
Fuel left in the fuel tank
deteriorates
and will cause serious starting
problems.
Using a fuel stabilizer:
Read the product
manufacturer's
instructions
and
recommendations.
Add to clean, fresh gasoline the correct amount of
stabilizer
for the capacity (approximately
3 gallons) of
the fuel system.
Fill the fuel tank with treated fuel and run the
engine for 2-3 minutes to get stabilized
fuel into the
carburetor.
Emptying
the fuel system:
Prior to putting
the tractor in storage, monitor
fuel
consumption
with the goal of running the fuel tank
empty.
Run the engine until it begins to stall. Use the choke to
keep the engine running
until all fuel in the carburetor
has been exhausted.
Referring to the engine manual, drain the fuel from the
carburetor
bowl.
3. Clean the engine and the entire tractor thoroughly.
4. Fully charge the battery, then disconnect
the negative
cable at the battery to prevent possible discharge.
Recharge the battery
periodically
when in storage.
NOTE: Remove the battery if exposed to prolonged
periods of sub-freezing temperatures. Store in a cool, dry
location where temperatures are above freezing.
SECTION 6
--
MAINTENANCE
ADJUSTMENTS
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rzt50

Tabla de contenido