Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Service
7
Battery Removal
_
WARNINGh
Battery posts, terminals
and
related accessories contain lead and lead
compounds.
Wash hands after handling.
The battery
is located on the right/rear
of the tractor
beneath the seat box frame. To remove the battery:
•
Remove the two hex tapping
screws from the battery
holddown
bracket and remove the bracket. Use care
to avoid losing the trim strip from the bottom
of the
bracket. See Figure 7-I.
Battery Holddown
Bracket
Hex Tapp Screw
v
\
Trim Strip
Figure 7-1
•
Remove the hex cap screw and sems nut securing the
black negative battery
lead to the negative
battery
post (marked NEG). Move the cable away from the
negative battery
post.
•
Remove the hex cap screw and sems nut securing the
red positive battery lead to the positive battery
post
(marked POS).
•
Carefully
lift the battery out of the tractor.
Install the battery
by repeating
the above steps in the
reverse order.
_
WARNING!" Always connect the positive lead
to the battery before connecting
the negative
lead. This will prevent sparking or possible
injury from an electrical
short caused by
contacting
the tractor body with tools being
used to connect the cables.
Charging the Battery
Test and, if necessary, recharge the battery after the tractor
has been stored for a period of time.
•
A voltmeter
or load tester should read 12.6 volts (DC) or
higher across the battery terminals.
•
Charge the battery with a 12-volt battery charger at a
MAXIMUM
rate of 10 amps.
Voltmeter
State of
Charging
Reading
Charge
Time
12.7
100%
Full Charge
12.4
75%
90 Min.
12.2
50%
180 Min.
12.0
25%
280 Min.
Servicing Electrical System
A fuse is installed
to protect the tractor's
electrical
system
from damage caused by excessive amperage.
Always use
the same capacity fuse for replacement.
If the electrical
system does not function,
check for a blown fuse. See
Figure 7-2.
GOOD
BAD
Figure 7-2
If you have a recurring
problem
with blown fuses, have
the tractor's electrical
system checked by your Cub Cadet
dealer.
Relays and Switches
There are several safety switches in the electrical
system. If
a function
of the safety interlock system described
earlier
is not functioning
properly,
have the electrical
system
checked by your Cub Cadet dealer.
Deck Removal
Remove the mower deck from the tractor as follows:
1. Move the tractor to a level surface, disengage the PTO,
stop the engine, and set the parking
brake.
2. Move the deck gauge wheels or rollers to their highest
setting
(lowest deck setting).
3. Remove the 'V' belt from the PTO pulley, located on the
bottom
of the engine, using one of the following
two
methods.
_
WARNINGh
The muffler
at the rear of the
tractor may be extremely
hot, and could cause
serious burns. Use extreme caution when near
the muffler. Allow the muffler
to fully cool
before removing
the belt from the PTO pulley.
Releasing
belt tension
with the idler pulley.
•
Using the deck lift handle, raise the deck to the
position
that provides the most horizontal
run of the
belt between
the deck idler pulleys and the PTO pulley
on the bottom
of the engine.
Publicidad
Tabla de contenido
