Any other servicing should be done by an authorized service representative. If appliance is not
working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it
to a service center prior to continuing use.
WARNING
PROBLEM
Dust escaping
from vacuum
Smokey/burning
smell detected
Vacuum tools
won't pick up
Poor suction
Vacuum running
warm
To reduce the risk of personal injury - Turn off before cleaning or servicing.
POSSIBLE CAUSE
1. Dirt cup full.
2. Dirt cup not installed
correctly.
3. Rinsable and/or
Cyclonic Filter not
installed completely.
1. Belt broken or stretched.
2. Brushroll is clogged.
1. Dirt cup full.
2. One or both filters are
clogged.
3. Stair + upholstery tool
not spinning.
4. Power carpet nozzle not
spinning.
1. Dirt cup not seated
completely.
2. One or both filters
clogged.
3. Dirt Cup not installed
correctly.
4. Battery charge is getting
weak.
5. Filter is dirty.
6. Clogged filter.
7. Nozzle/dirt passage
clogged.
1. Dirty filter (s)
2. Low suction.
POSSIBLE SOLUTION
1. Empty dirt cup. (see page 9)
2. Review Dirt Cup removal & replacement.
(see page 6)
3. Review Filter Removal and Cleaning.
(see page 10 & 11)
1. Call Customer Service: 1-800-321-1134.
2. Clear/remove debris from brushroll.
1. Empty dirt cup. (see page 9)
2. Remove both filters and clean.
(see page 10 & 11)
3. Remove and reattach. (see page 12)
4. Remove and reattach. (see page 12)
1. Reinstall dirt cup make sure lid is closed
completely. (see page 6)
2. Remove both filters and clean.
(see page 10 & 11)
3. Review Filter Removal & Replacement
(see page 6)
4. Charge battery. (see page 8)
5. Clean or replace filter. (see page 10 & 11)
6. Remove filter and clean. (see page 10)
7. Turn off the unit and then disconnect the
nozzle to remove debris. (see page 12)
1. Clean filter, rinse, dry and re-assemble.
(see page 10)
2. Locate clog and remove.
15