Mounting The Axis - Festo ELGA-TB-G Instrucciones De Utilizacion

ELGA-TB-G/-KF/-RF
Mounting position vertical or diagonal
WARNING
Uncontrolled payload if there is a power failure or
the toothed belt breaks.
Injury due to impacts or pinching.
With vertical or diagonal mounting position:
• Use motors with spring-loaded holding brakes.
• Take appropriate precautionary measures against
damage resulting from belt failure (e.g. toothed
pawls, pins or emergency buffers).
5.1.1

Mounting the axis

Prerequisites
• Position the product in such a way that its control sections are accessible (e.g. relubrication open­
ings).
• Install product without tension or distortions.
• Fasten product to a mounting surface with flatness of 0.05 % of
the stoke length, but max. 0.5 mm.
• In the case of gantry structures, attention must also be paid to
parallel alignment or product height in the alignment of the axes.
Further requests contact your local Festo Service centre.
• Take the required support clearances into consideration
(è 13 Characteristic curves).
Festo – ELGA-TB-G/-KF/-RF – 1512d English
Fig. 6
Fig. 7
33