Dismounting And Mounting The Electronics Module - Festo CPX-FVDA-P Manual De Instrucciones

CPX-FVDA-P
Note
The DIL switch is a mechanically sensitive component due to its size.
S To set it, use a suitable small, blunt tool (e. g. a watchmaker's screwdriver)
and proceed very carefully.
1. Switch off the power supplies for the CPX terminal.
2. Remove the mounted connection block (
3. Carefully set the DIL switch as desired by using a suitable tool, e.g. a small
watchmaker's screwdriver.
4. Remount the connection block. Observe the tightening torques when doing
this!

Dismounting and mounting the electronics module

Note
Incorrect handling can cause damage to the electronics modules.
S Never pull out the electronics module from the interlinking block or push it
into the interlinking block when powered!
To avoid errors in mounting, both the interlinking block CPX-M-GE-EV-FVO and the
electronics module CPX-FVDA-P are mechanically coded. The coding prevents a
different module from being plugged into the interlinking block or the module from
being plugged into an incorrect interlinking block.
The plugs connected to the connection block may remain attached whilst dismant-
ling the connection block.
Dismantling the electronics module
1. Switch off the operating and load voltage supplies.
2. Unscrew the screws 9 and carefully lift off the connection block 1.
3. If required: pull the electronics module 2 carefully from the contact rails.
Festo CPX-FVDA-P-Z6 1303a English
Fig. 4).
Fig. 4:
35