Attaching The Src-System - SCHUBERTH SRC-SYSTEM Manual Del Usuario

1. Pull out the antenna connector (marked with a red tag) which is tucked inside
the back rim of the helmet.
Antenna tag visible
2. On the SRC collar open the two fasteners on the
antenna connector and remove the protective
plastic cover.
3. On the helmet remove the rubber protector
from the antenna connector.
4. Align the two connector heads and snap the two
fasteners back into place to lock the connector
in a closed position.
10
Antenna connector
pulled out
A. B.
A.
antenna-plug (helmet) unsealed (with
B. arrows)
5. The antenna connector can now be safely
stowed away inside the antenna connector
pocket on the center of the SRC-System™.

6.3 ATTACHING THE SRC-SYSTEM

™
1. Make sure to place the speaker cords inside the helmet, and then secure the
SRC-System™ into place.
2. Slide and insert the pin located at the edge of the control panel into its
corresponding indentation on the helmet and close the snap button.
Pin
3. Insert the other pin on the opposite side of the Acoustic Collar into place and
close the second snap button.
4. Push and insert the Acoustic Collar starting from the center area to the back of
the helmet area. Do the same for the remaining parts to secure the Acoustic
Collar into place.
5. Make sure that both snap buttons remain fastened, and that the microphone
boom is located on the inner side of your helmet (between the SRC-System™
and the inner padding of the helmet).