Installation And Operation; Installation; Unpacking; Preset - Bartscher 2Z 126FL Manual De Uso

5. Installation and operation

5.1 Installation

5.1.1 Unpacking

The device should be unpacked in the following way:

Remove the device from the carton box, then remove the external and internal
package.

Clean the interior with warm water and soft cloth. Follow instructions in section 6
"Cleaning".

In order to avoid scratches and stains remove the protective foil just before installing
the device in its place.
CAUTION!
Never remove the rating plate or any warning signs from the device.

5.1.2 Preset


Place the device on an even and safe surface which supports the weight of the
device and assures stability at full load.

Do not place the device in direct sunlight or in the vicinity of heat sources (cooker,
radiator, heating devices, etc.). Direct sunlight may cause changes in the acrylic
surface and the heat sources have negative impact on energy consumption.

The ambient temperatures below 16 °C and above 38 °C may lead to limited
functionality of the device.

The device is designed for indoor operation only. Never place the device in humid or
wet environment.

Do not place the device in hot environment or in the vicinity of flammable materials.

The device requires sufficient air circulation for correct operation. Assure the
minimum side distance of 10 cm of the device.

Do not remove or block the holes of the device.

The electric socket should be easily accessible so it it possible to quickly disconnect
the supply cable when necessary.

Installation and assembly of this device in the non-stationary location (e.g. ship)
should be realized by the specialized companies/persons only, after assuring the
fulfilment of conditions necessary for safe operation of the device.
- 33 -