Feet; Fixing Of Handle; Wooden Shelves - Bartscher 2Z 126FL Manual De Uso


Due to energy savings make sure that the door of the device is closed during its
operation.

In case of moving the device to another location disconnect the power supply and
remove the plug from the socket. Remove all content from the device. Due to safety
reasons fix all loose elements inside. Fix the door with use of adhesive tape. The
wine cooler should be transported in the vertical position only.

5.1.3 Feet

The device is equipped with 3 large feet and 1 small adjustable foot. Adjust the foot in
such way that the device stands straight and does not sway.

5.1.4 Fixing of handle

Before the first use fix the supplied stainless steel
handle to the device door with use of screws.
Move the rubber seal on the door internal side left or
right to uncover the fixing holes. Fix the handle to the
door using supplied set of screws.
Then replace the seal in correct position.

5.1.5 Wooden shelves:

Each wooden shelf may be removed to allow for storage of bigger bottles.
Intermediate shelf
Before removing the shelf the bottles must be removed first. Then lift the shelf slightly
and pull it out (loose the screws when required).
NOTE!
Make sure that the wooden shelves are properly snapped before placing
bottles on them. Pay attention to uniform distribution of load inside the device.
- 34 -
Lower shelf