Bartscher 2Z 126FL Manual De Uso página 43

Failure
The light is not working.
Vibrations.
The device operation is too
loud.
The door is not closing
properly.
LED display is not showing
anything.
LED display: "Lo".
The buttons are not
working.
The compressor does
not start.
The compressor starts
again.
Dew on the cooler surface.
Bubbling sound of a liquid.
Condensate in the cooler.
Error E2.
Possible cause/solutions
- Contact the service company.
- Check if the device is levelled.
- The device is not levelled.
- Check fan.
- Loose parts.
- The device is touching the wall.
- The device is not levelled.
- The door is installed in the opposite way
or incorrectly.
- Worn out seal.
- Lowered shelves.
- The main switchboard is not working.
- Damaged power supply plug.
- Problem in the printed circuit.
- Contact the service company.
- The temperature controller is damaged.
- The compressor does not start when the ambient
temperature is lower than the preset temperature.
- The compressor stops working after reaching the
preset temperature but starts again until the preset
temperature is reached.
- Dew appears on the front glass, especially when
the device operates in humid environment. It is
connected with humidity of air contacting the wine
cooler. Remove dew using a soft cloth.
- Sound of compressor operation when it starts or
stops.
- Sound of refrigerant in the circuit.
- The door has been left opened for a long time in
humid environment or has been opened frequently.
Leave the door closed for as long as possible.
- Contact the service company.
- 39 -