Maintenance; Light Bulb Replacement - Dimplex DS5629 Manual De Instrucciones

Maintenance

 W ARNINg: Disconnect power
before attempting any main-
tenance or cleaning to reduce
the risk of fire, electric shock
or damage to persons.

Light Bulb Replacement

allow at least 5 minutes for light
bulbs to cool off before touching
bulbs to avoid accidental burning
of skin.
Light bulbs need to be replaced
when you notice a dark section of
the flame or when the clarity and
detail of the log exterior disap-
pears. There are two bulbs under
the log set which generate the
flames and embers.
Tool Requirements - Phillips
screw driver
Helpful Hints: It is a good idea to
replace all light bulbs at one time
if they are close to the end of their
rated life. Group replacement will
reduce the number of times you
need to open the unit to replace
light bulbs.
Upper Light Bulb Requirements
Quantity of 1 clear chandelier or
candelabra bulbs with an E-12
(small) socket base, 7 watt rating.
Upper Bulb Replacement
1. open door by pulling the
10
handle.
2. Locate the upper bulb brack-
et.
3. Bend light retainer bracket
down.
4. Locate and remove the light
bulb.
5. Insert new bulb.
6. Bend light retainer bracket
back into its original position.
7. Close the door.
Lower Light Bulb Requirements
Quantity of 2 clear chandelier or
candelabra bulbs with an E-12
(small) socket base, 60 watt rat-
ing.
Lower Bulb Replacement
1. open door by pulling the
handle.
2. Remove the screw from the
logset located in the center
of the emberbed and remove
the logset from the unit.
3. Locate and examine the bulbs
to determine which bulb(s)
required replacement.
4. Locate and remove the light
bulb(s).
5. Insert new bulb(s).
6. Install the logset into the unit,
pushing firmly against the
www.dimplex.com