Install The Hood; Connect Wiring; Reinstall Blower Wheel And Bottom Panel - Best UCB3I Serie Instrucciones De Instalación

6. INSTALL THE HOOD

6.1
Run power cable to installation location. Position the hood in its intended
location. Using a pen, mark the position of the screws (as shown at right).
Remove the hood.
6.2
Install the first four no. 8 x 1/2'' screws, leaving a 1/8'' gap (do not install screws nos. 5, 6, 7, 8 and 9 yet).
6.3
Install the wire clamp and insert the power cable in the hood. Place the hood under the cabinet, slide it in position and tighten the wire
clamp to secure the cable. Make sure the adapter/damper enters the duct opening. Tighten the first 4 screws completely, then add the
last screws (screws nos. 5, 6, 7, 8 and 9) in the center holes. Make sure the damper flap opens freely.
7.

CONNECT WIRING

Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power to be switched on accidentally.
Connect cable to range hood wiring using included wire connectors.
Connect BLACK to BLACK, WHITE to WHITE and GREEN or BARE WIRE to GREEN
ground screw. DO NOT FORGET TO CONNECT THE GROUND.

8. REINSTALL BLOWER WHEEL AND BOTTOM PANEL

When reinstalling the blower wheel, make sure the small tab is aligned with the yellow label on the motor.
8.1
Reinstall blower wheel: Using both hands, gently push on
the blower wheel until secured.
8.2
Insert bottom panel in the back of the hood.
8.3
Secure bottom panel to the hood, using the 7 or 8 screws
previously removed in step 3.2.
1
2
HD0554
WARNING
!
HE0059
CAUTION
HO0168
7
8 7 6
9
5 3
4
G
ROUND
SCREW