Remove Grease Filter(S); Install The Hood - Best WCN1 Serie Instrucciones De Instalación

6. REMOVE GREASE FILTER(S)

Lay the back side of the hood flat on a table. Use a piece of cardboard to
avoid damaging the table or the hood.
To remove the grease filters, push the filter latch down and tilt each filter
downward. Set filters aside.
Install the damper using 4 M4 x 8 Phillips round head screws.
Detach the junction box cover from the top of the hood by removing both retaining
screws. Set aside the cover and the screws.

7. INSTALL THE HOOD

BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
1. Align the hood and center it above the hood mounting bracket. Gently lower
the hood until it securely engages the bracket.
2. Level the hood.
3. With the hood hanging in place, mark the four hole locations on wall (see
illustration at right).
4. Remove the hood.
5. Drill through marked holes on wall using a 3/32" drill bit.
6. Hang the hood to the wall bracket.
7. Secure the hood to the wall using 2 #8 x 1-1/2" Phillips flat head screws for top holes. Use 2 washers and 2 #8 x 1-1/2" Phillips flat head
screws for bottom holes.
HD1269
WARNING
!
5
B
C
HO0389
HO0384
H
OLE LOCATIONS