Plug In Refrigerator; Move Refrigerator To Final Location; Lower Leveling Legs - Thermador KBULT3651A Instrucciones De Instalación

Ocultar thumbs Ver también para KBULT3651A:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Style 2 - Shutoff Valve Connection
1. Unplug refrigerator or disconnect power.
2. Remove the shipping tape from the gray, coiled water tubing
on the rear of the refrigerator.
3. Thread the provided nut onto the water valve as shown.
NOTE: Tighten the nut by hand. Then tighten it with a wrench
two more turns. Do not overtighten.
A. Bulb
B. Nut (provided)
4. Turn shutoff valve ON.
5. Check for leaks. Tighten any nuts or connections (including
connections at the valve) that leak.
6. Plug in refrigerator or reconnect power.
7. Flush the water system.
NOTE: Allow 24 hours to produce the first batch of ice. Discard
the first three batches of ice produced. Allow 3 days to
completely fill ice container.
P l u g i n R e f r i g e ra t o r
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Set control switch at top of cabinet to the OFF position.
2. Plug into grounded 3 prong outlet.
18
M ove R e f r i g e ra t o r t o F i n a l
A
Refrigerator is top heavy and tips easily when not
B
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure do so can result in death or serious injury.
IMPORTANT: To prevent floor damage, make sure levelers are
raised (not touching floor) and refrigerator is on rollers before
moving.
1. Place top of cardboard carton or plywood under refrigerator.
Remove dolly.
2. Do not remove protective film or cover.
3. Move the refrigerator straight back and evenly into the
opening. Be sure that water tubing is not kinked and the
power supply cord is on top of the refrigerator next to the
cover.
NOTE: All four leveling legs must contact the floor to support and
stabilize the full weight of refrigerator. Rollers are for moving
refrigerator and not for permanent support.
Use socket wrench to turn leg levelers on both sides of
refrigerator to the right (clockwise) until refrigerator weight is
supported by leveling legs. The rollers should be off the floor. To
avoid cabinet damage, do not apply more than 50 inch-pounds
(58 cm - kg) of torque to the leveling legs.
Lo c a tio n
WARNING
Tip Over Hazard
L owe r L eve l i n g L e g s
A B
A. Rear leveling legs
B. Front leveling legs

Publicidad

Tabla de contenido
loading

Tabla de contenido