Ice Storage Bin Installation - Motak PKU0155SA Manual De Instrucciones

Section 1

Ice Storage Bin Installation

Warning
n
To avoid instability, the equipment must be installed in an area capable of supporting
the weight of the ice machine and a full bin of ice (30" models 750 lbs [340 kg]). The bin
and must be level side-to-side and front-to-back before installing the ice machine.
1. Remove threaded plug from drain fitting.
2. Screw the leveling legs onto the bottom of the bin.
3. Screw the foot of each leg in as far as possible. The legs must be screwed in tightly to
prevent them from bending.
4. Move the bin into its final position.
5. Level the bin to assure that the bin door closes and seals and the ice machine
operates properly. Use a level on top of the bin. Turn the base of each foot as
necessary to level the bin.
6. Inspect bin gasket prior to ice machine installation.
7. Remove all panels from ice machine before lifting and installing on bin. Remove front
panel, top cover, left and right side panels.
8. Install a separate bin drain refer to "Drain Connections" on page 18 for drain
requirements.
Part Number: 000016426 Rev 00 08/2020
Installation Instructions
13