Part Removal For Detailed Descaling/Sanitizing; Pkm0335/Pkm0425/Pkm0535 Part Removal - Motak PKU0155SA Manual De Instrucciones

Cleaning and Sanitation

Part Removal for Detailed Descaling/Sanitizing

PKM0335/PKM0425/PKM0535 PART REMOVAL

A. Remove the water curtain.
• Gently flex the curtain in the center and remove it from the right side.
• Slide the left pin out.
B. Remove the water trough.
• Depress tabs on right and left side of the water trough.
• Allow front of water trough to drop as you pull forward to disengage the rear pins.
C. Remove the ice thickness and harvest float switches.
• Pull the float switch straight down to disengage.
• Lower the float switch until the wiring connector is visible.
• Disconnect the wire lead from the float switch.
• Remove the float switch from the ice machine.
D. Remove the water distribution tube.
NOTE: Distribution tube thumbscrews are retained to prevent loss. Loosen thumbscrews
but do not pull thumbscrews out of distribution tube.
• Loosen the two outer screws (do not remove screws completely they are retained to
prevent loss) and pull forward on the distribution tube to release from slip joint.
• Disassemble distribution tube by loosening the two (2) middle thumbscrews and
dividing the distribution tube into two pieces.
• Proceed to page 34, Step 6.
A
36
D
Part Number: 000016426 Rev 00 08/2020
Section 3
C
B