Motak PKU0155SA Manual De Instrucciones página 38

Cleaning and Sanitation
5. Remove the water distribution tube.
A. Loosen the two thumbscrews, which secure the
distribution tube.
B. Lift the right side of the distribution tube up off
the locating pin.
C. Slide the distribution tube back.
D. Slide the distribution tube to the right and
remove.
Dissemble the distribution tube – twist both of
the inner tube ends until the tabs line up with the
keyway and pull the inner tube ends outward.
6. Remove the float valve.
• Turn the splash shield counterclockwise one or
two turns and pull the float valve forward and off
the mounting bracket.
• Disconnect the water inlet tube from the float
valve at the compression fitting.
• Remove the cap and filter screen for descaling.
7. Remove the water trough.
Apply downward pressure on the siphon tube and
remove from the bottom of the water trough.
Remove the upper thumbscrew and, while supporting
the water trough, remove the two thumbscrews from
beneath the water trough.
38 Part Number: 000016426 Rev 00 08/2020
Section 3
D
C
B
A