Sanitizing Procedure - Motak PKU0155SA Manual De Instrucciones

Cleaning and Sanitation
Step 4
Wait until the cycle is complete. Then disconnect power to the ice machine (and
dispenser when used).
Warning
n
Disconnect the electric power to the ice machine at the electric service switch box.
Step 5 Remove parts for descaling.
Please refer to parts removal and continue with step 6 when the parts have been
removed - Refer to "PKM0335/PKM0425/PKM0535 Part Removal" on page 36 or
"PKU0155 Part Removal" on page 37.
Step 6
Mix a solution of descaler and lukewarm water. Depending upon the amount of
mineral buildup, a larger quantity of solution may be required. Use the ratio in the table
below to mix enough solution to thoroughly descale all parts.
Solution Type
Descaler
Step 7 Use 1/2 of the mixture to descale all components. The solution will foam when
it contacts lime scale and mineral deposits; once the foaming stops use a soft-bristle nylon
brush, sponge or cloth (NOT a wire brush) to carefully descale the parts. Soak parts for 5
minutes (15-20 minutes when heavily scaled). Rinse all components with clean water.
Step 8 While components are soaking, use 1/2 of the solution to descale all foodzone
surfaces of the ice machine and bin (or dispenser). Use a nylon brush or cloth to
thoroughly descale the following ice machine areas:
• Evaporator plastic parts – including top, bottom and sides
• Bin bottom, sides and top
Rinse all areas thoroughly with clean water.

SANITIZING PROCEDURE

Step 9 Mix a solution of sanitizer and lukewarm water.
Solution Type
Sanitizer
Step 10 Use 1/2 of the sanitizer/water solution to sanitize all removed components. Use
a spray bottle to liberally apply the solution to all surfaces of the removed parts or soak
the removed parts in the sanitizer/water solution. Do not rinse parts after sanitizing.
34
Water
1 gal. (4 L)
Water
3 gal. (12 L)
Part Number: 000016426 Rev 00 08/2020
Section 3
Mixed with
16 oz (500 ml) descaler
Mixed with
2 oz (60 ml) sanitizer