Dispenser Installation; Air Gap - Motak PKU0155SA Manual De Instrucciones

Installation Instructions

Dispenser Installation

Observe the following recommendations unless required by the dispenser manufacturer.
• An adapter is not required for ice machines that match the dispenser size.
• A deflector is required for dispensers.
• Ice level management is recommended to prevent water leakage or movement of ice
machine during agitation.
• Align sides and back of ice machine with sides and back of dispenser when placing ice
machine.
• Follow ice machine installation procedures in this manual and any additional installation
requirements specified by the dispenser manufacturer.

Air Gap

A greater than 1-inch (25 mm) air gap is built into the ice machine for back-flow
prevention. This air gap exceeds NSF 12 requirements for back-flow prevention.
This air gap is greater than 1" (25 mm)
14 Part Number: 000016426 Rev 00 08/2020
Section 1