Water Maintaince And Chemicals - mspa Alpine El Manual Del Propietario

NOTE: Default setting temperature is 38°C; Temperature setting range: 20 - 40°C.
Controller Locking: Press UP and DOWN button at the same time for 3s, the buzzer will ring 3
times, meaning that the controller is locked. In this mode, function will not be turned on if the button
is pressed. Press UP and DOWN button at the same time again for 3s to unlock the controller.
Timer Button:
DOWN button, you can set and start heating automatically in up to 99 hours. The TIMER setting is
TIMER
confirmed if no further operation in more than 3s or press TIMER button again. The heater will start
working after current setting hours. The setting hour can also be changed by entering the
pre-setting mode again. The light of TIMER button flashes green when activated.
Cancel: Press the TIMER button for 3s to cancel the pre-setting.
NOTE: The pre-setting function cannot be turned on during heating process. The pre-setting mode
will also end after heating function is on or after the spa is reboot.
Filter Cartridge Cleaning Reminder: When red light keeps flashing (Filter
function is OFF) or red and green lights alternately flashing(Filter function is
ON), the filter cartridge shall be cleaned or replaced. After that, press Filter
button for 3s to delete the reminder.
IMPORTANT: The following conditions will lead to slow water heating
MAINTENANCE
Filter Cumulative use up to 150hrs, or cleaning
Cartridge reminder is activated
Not in used for 2~3 days or longer
SPA
Check water quality in time and adjust to
recommended range
WATER MAINTENANCE AND CHEMICALS
Water Sanitation
The spa owner must regularly check and keep the spa water sanitized with scheduled maintenance (daily, if
necessary). Adding sanitizer or other chemical will control bacteria and viruses reproduction in the spa water.
The maintenance of a proper water balance through appropriate use of sanitizers is the most important factor in
maximizing the life and appearance of the spa as well as ensuring clean, healthy and safe water.
Proper technique is important for water testing and treating the spa water. See your spa professional for
chemical, sanitizer, test kit and testing procedures questions.
Press the TIMER button to enter intelligent pre-setting mode. By pressing UP and
FREQUENCY
Clean the filter cartridge or change a new one
The filter cartridge may need to be replaced
within 150hrs for initial use.
Use an overall cover for protection
Use water treatment products to adjust
16
ACTION