The appliance has been tested be fore being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and ma lfunctions which might occur dur ing
use.
Faults
Smell of gas
The pilot light does not ignite
The pilot light goes out
The flame is yellow
Burner control knob is stiff
IT
IT
GB
GB
DE
DE
FR
FR
ES
ES
English
TROUBLESHOOTING
Occasional leak because
The spark ignition devices
The thermocouple has not
Burner dirty, heat exchange pipes
clogged, condensation drips
Gas control valve malfunction
FAULT
The user ca n solve some of these problems him-
self, but for others specific technical knowledge or
skill is req uired, and so they must only be carr ied
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
flame has gone out
are not working
Air in pipelines due to
long period out of use
warmed up enough
- 16 -
Remedies
Turn off the gas supply tap and
ventilate the room
Check that the ignition devices
are in good working order.
Light by hand with a naked light.
Important
Contact the after-sales service
Make more attempts
to light the flame
Make more attempts
to light the flame
Important
Contact the after-sales service
Important
Contact the after-sales service
6