Cleaning Oven; Checking Gas Pressure - Angelo Po 1G0TP0 Manual De Uso E Instalación

CLEANING OVEN

To carry out this operation, proceed as follows.
1 - Remove the bottom plate (C) and the gr id (D)
from the oven and clean them thoroughly.
2 - Clean the inside parts of the oven to remove
any deposits which may impair its operation.
3 - Dry the surfaces and reassemble the compo-
nents.

CHECKING GAS PRESSURE

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the scr ews (B) and remo ve the control
panel (C).
4 - Undo the screw (D) of the pressure connection.
5 - Connect the pressure gauge (E) to the pressure
test point (F).
6 - Turn the gas supply tap back on.
7 - Light one of the burners, turn the knob to the full
flame setting (see page 10) then check that the
pressure reading is the same as the values pro-
vided in the table (see back of manual).
C
A
- 15 -
D
C
8 - Switch off the burner, turn off the gas sup-
ply tap and disconnect the pre
gauge.
9 - Restore the initial conditions after com-
pleting the operation.
B
D
IDM-39618700700.tif
ssure
E
F
IDM-39618700800.tif
English
IT
GB
DE
FR
ES