Angelo Po 1G0TP0 Manual De Uso E Instalación página 57

ADJUSTING TOP BURNER PRIMARY AIR
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off the knob (A).
3 - Undo the screws (B) and
remove the control panel
(C).
4 - Undo the locking screw
(D).
5 - Set the bush (E) at the
distance (F) shown in the
table.
6 - Tighten the screw (D).
7 - Replace the control panel (C) and the knobs (A)
on completion of the operation.
ADJUSTING TOP BURNER PRIMARY AIR
To carry out this opera tion,
proceed as follows.
1 - Turn off the g as supply
tap.
2 - Pull off the knob (A).
3 - Undo the screws (B) and
remove the control panel
(C).
4 - Undo the scr ew (D) and
lift the burner support (E)
as far as it will go.
5 - Tighten the screw (D).
6 - Replace the control panel
(C) and the knobs (A) on
completion of the operation.
C
A
Gas family
II (G 20/20mbar)
II (G 25/20-25mbar)
III (G 30-31/29-37mbar)
III (G 30-31/50mbar)
B
C
A
- 25 -
E
F
B
E
IDM-39618701400.tif
Distance (F) (mm)
13±1
13±1
-
-
E
IDM-39618701500.tif
D
IT
GB
DE
D
FR
ES
English